pond garden pond water garden fish pond frog pond

"Your pond products really work well & the service is great!  Thanks for such a great website!" D. Strickrodt

Prompt shipping!
Orders usually ship within 24 hours!

Over 5,000 pages of pond products and information!

 

                

                      Site Search

How to Install a Pre-formed Pond

 

St Croix Pre-Formed Pond.jpg (25021 bytes)

1.  Select an area that is sunny and has at least 4-6 hours of sunlight.  Good drainage is a must.  Root free would be great, too.

 

wpe2B.jpg (1659 bytes)

 

Dig hole and outline.jpg (32981 bytes)

2.  Standing inside the pond, mark the pond's perimeter on the ground, using an edger or
flat shovel.  You can outline it with chalk dust as well.
 

wpe2B.jpg (1659 bytes)

 

Dig hole larger than pond.jpg (33252 bytes)

3.  Dig a corresponding hole a little larger and deeper than the pond.  Make sure the excava- tion has a firmly compacted base.   Take out any rocks, roots, or sharp debris.  You can put approx. 2" of play sand base under the pond and have some for around the edges.  NOTE:  For our molded shelf ponds, simply replicate the pond's contour within the excavation, making sure to fully support the shelf with tightly packed sand or dirt.  Rinse out pre-formed pond with water real well before installing.
 

wpe2B.jpg (1659 bytes)

 

Level pond.jpg (22309 bytes)

4.  Bed the pond on a layer of sand, then level the pond.  You should have the pond's edge slightly above ground level so the dirt around it slopes at least 10% away from the pond to prevent rain from washing soil, lawn fertilizers, etc. into the pond.
 

wpe2B.jpg (1659 bytes)

 

Backfill in pond.jpg (29103 bytes)

5.  Backfill with loose dirt or sand between pond and excavation, stopping at halfway mark between excavation base and pond's flange (upper lip).  Start to fill with water.
 

wpe2B.jpg (1659 bytes)

 

Fill pond.jpg (26208 bytes)

6.  Commence filling with water slowly and continue backfilling with loose sand.  Gauge your time so the filling of water and backfilling of sand steps are finished at the same time.  If water is chlorinated, allow 48 hours before adding plants.  If you are adding fish, you need to dechlorinate the water by using Ammo Lock 2 before adding fish. If you got dirt in the pond while backfilling, it is a good idea to drain the pond completely, wipe clean (never use detergents) and refill with water.
 

wpe2B.jpg (1659 bytes)

 

Decorate with rocks.jpg (34146 bytes)
A layer of washed, lightly colored stone (pea gravel, cobblestones) may be arranged within the pond prior to stocking.  Dirt and sediment will rest upon the rocks, becoming less noticeable.

Decorate with rocks, bridge, aquatic plants, lighting, fountains, or whatever your imagination decides!

 

wpe2B.jpg (1659 bytes)

 

Decorate with rocks or bridge.jpg (57178 bytes)

Combine two or more ponds for a larger, more dramatic presentation.  Pictured here are the Lotus and 2 St. Croix pre-formed ponds.
 

wpe2B.jpg (1659 bytes)

 

Home         Pre-formed Ponds

 

Privacy Pledge      |     Ordering Info   |     View Your Shopping Cart    |    Report Bad Link    |   Return Policy

 

The information presented in this site is intended to assist you in creating and maintaining your ornamental pond. We
cannot be responsible for your interpretation of any product's specific use, instructions, misstatements or typographical errors.

© Copyright 1999 - 2008, Pond and Landscape Solutions, Inc.   All Rights Reserved. 
This copyright is protected under federal law.  Copying any portion of this website is strictly prohibited. 
Violators will be punished to the fullest extent of the law.